Relay Control of Retained Accessory Power (RAP)

The body control module (BCM) keeps the internal RAP relay energized during all power modes, except Off-Awake and Crank. The relay is also energized for approximately 10 minutes after shutting the ignition OFF and removing the key, providing no door is opened. The BCM will de-energize the internal RAP relay at the same time the serial data message is sent to end RAP. When the internal RAP relay is energized voltage is applied on the accessory voltage circuit at BCM harness connector X5 terminal 11.

The devices powered by the internal RAP relay during the RAP power mode are the sunroof (CF5), the RAP/Spare PCB relay, and if equipped with RPO 9L4, the radio module fuse block relay A.