LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2008 >> Escalade EXT >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Object Detection System >> Diagnostic Information and Procedures >> Information Center Telltale Malfunction >> Component Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Testing

  1. Ignition OFF, disconnect the harness connector at the RPA display.
  2. Connect a 10A fused jumper wire between the 12V supply circuit terminal 1 and B+.
  3. Connect a 10A fused jumper wire between the control circuit terminals listed below and ground.
    • Left amber LED control circuit terminal 2
    • Center amber LED control circuit terminal 3
    • Red LED control circuit terminal 4
  4. Verify that the appropriate LED illuminates.
    • If the component does not perform as specified, replace the RPA display.
scientia non olet · About LEMON Manuals