Circuit/System Verification
- Inspect the rearview camera for any debris on the lens or a damage bezel or bezel seal.
- Clean any debris from the lens. If the lens, bezel, or bezel seal are damaged, replace as necessary.
- Ignition ON, vehicle in PARK, verify the backup lamps are off.
- Command the backup lamps ON with a scan tool. A clear rearview image should be displayed on the radio.
- If a clear image is not displayed, refer to Rear Vision System Does Not Display in Circuit/System Testing .
- If the Service Rear Vision Camera System message is displayed, refer to Service Rear Vision Camera System is Displayed in Circuit/System Testing .