Component Testing
IMPORTANT:
When performing the following tests, make sure that the device is not already in the position step 1 is attempting to produce. If it is, start with step 2 then perform step 1.
- Ignition OFF, disconnect the harness connector at the appropriate window motor.
- Install a 25-amp fused jumper wire between the control terminal A and 12 volts. Momentarily install a jumper wire between the control terminal B and ground. The window motor should perform the UP or DOWN function.
- If the function does not perform as specified, replace the window motor.
- Reverse the jumper wires; the window motor should perform the DOWN or UP function.
- If the function does not perform as specified, replace the window motor