Fuel Tank Pressure Sensor: Service and Repair

Fuel Tank Pressure Sensor Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service Intervals) .
2. Disconnect the fuel tank pressure sensor electrical connector (1).





Important: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.


3. Remove the fuel tank pressure sensor from the evaporative emission (EVAP) canister.



Installation Procedure






Important: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.


1. Install the fuel tank pressure sensor to the EVAP canister until fully seated.




2. Connect the fuel tank pressure sensor electrical connector (1).
3. Lower the vehicle.