LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2008 >> STS Base, 4.6 A, AWD >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0292 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the Yaw Rate/Lateral Accelerometer.
  2. Test for less than 6 ohms of resistance between the low reference circuit terminal 5 and ground.
    • If greater than the specified range, test for an open/high resistance in the low reference circuit. If the circuit tests normal, replace the EBCM.
  3. Ignition ON, test for 11.8-12.2 volts between the 12-volt reference circuit terminal 3 and ground.
    • If less than the specified range, test the 12-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.
    • If greater than the specified range, test the 12-volt reference circuit for a short to voltage. If the circuit tests normal, replace the EBCM.
  4. If all circuits test normal, replace the Yaw Rate/Lateral sensor.
scientia non olet · About LEMON Manuals