LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2008 >> XLR V >> Repair and Diagnosis >> Accessories & Equipment >> Memory Modules >> Configurable Customer Control System >> Diagnostic Information and Procedures >> Steering Wheel Controls Inoperative (Mute/Seek) >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

IMPORTANT: It is recommended that Component Testing  be performed before Circuit Testing when diagnosing steering wheel controls.
CAUTION: Refer to SIR Caution .
  1. Ignition OFF, disconnect the X1 harness connector at the MUTE/SEEK + switch.
  2. Ignition ON, test for ignition voltage between the ignition circuit terminal 5 and ground.
    • If less than the specified range, test the ignition circuit for a short to ground or open/ high resistance. If circuit test normal, and the fuse is ok, replace Run/Crank relay.
  3. Test for 0 volts between the signal circuit terminal 6 and ground.
    • If greater than the specified range, test the signal circuit for short to voltage. If circuit test normal, replace BCM.
  4. Test for ignition voltage between the ignition circuit and the signal circuit terminal 6.
    • If less than the specified range, test the signal circuit for an open/high resistance. If circuit test normal, replace BCM.
  5. Ignition OFF, disconnect the X2 harness connector at the BCM.
  6. Test for infinite resistance between the signal circuit terminal 57 and ground.
    • If less than the specified range, test the signal circuit for short to ground. If circuit test normal, test or replace switch.
  7. If all circuits test normal, test or replace the switch.
scientia non olet · About LEMON Manuals