LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> DTS 4.6 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Object Detection System) >> Diagnostic Information and Procedures >> DTC B356A >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the headlamp switch.
  2. Test for less than 10 ohms between the ground circuit terminal 8 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool Mode Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 9 for a short to ground. If the circuit tests normal, replace the vehicle direction alert alarm warning module.
  4. Install 3A fused jumper wire between the signal circuit terminal 9 and ground. Verify the scan tool Mode Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the vehicle direction alert alarm warning module.
  5. If all circuits test normal, test or replace the headlamp switch.
scientia non olet · About LEMON Manuals