Component Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Lumbar Switch
- Ignition OFF, disconnect the harness connector at the lumbar switch.
- Test for infinite resistance between each lumbar direction signal terminal listed below and the B+ terminal G with the switch in the open position.
- Lumbar horizontal forward switch terminal B
- Lumbar horizontal rearward switch terminal C
- Lumbar vertical upward switch terminal F
- Lumbar vertical downward switch terminal A
- If not the specified value, replace the lumbar switch.
- Test for less than 1 ohm between each lumbar direction signal terminal listed below and the B+ terminal G with the switch in the closed position.
- Lumbar horizontal forward switch terminal B
- Lumbar horizontal rearward switch terminal C
- Lumbar vertical upward switch terminal F
- Lumbar vertical downward switch terminal A
- If greater than the specified range, replace the lumbar switch.
- Test for less than 1 ohm between each lumbar direction signal terminal listed below and the ground terminal E with the switch in the open position
- Lumbar horizontal forward switch terminal B
- Lumbar horizontal rearward switch terminal C
- Lumbar vertical upward switch terminal F
- Lumbar vertical downward switch terminal A
- If greater than the specified range, replace the lumbar switch.