Component Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the seat adjuster switch.
- Test for infinite resistance between each seat direction signal terminal listed below and the B+ terminal E with the switch in the open position.
- Front vertical upward switch terminal A
- Front vertical downward switch terminal K
- Rear vertical upward switch terminal F
- Rear vertical downward switch terminal J
- Horizontal forward switch terminal D
- Horizontal rearward switch terminal C
- Recline forward switch terminal H
- Recline rearward switch terminal G
- If not the specified value, replace the seat adjuster switch.
- Test for less than 1 ohm between each seat direction signal terminal listed below and the B+ terminal E with the switch in the closed position.
- Front vertical upward switch terminal A
- Front vertical downward switch terminal K
- Rear vertical upward switch terminal F
- Rear vertical downward switch terminal J
- Horizontal forward switch terminal D
- Horizontal rearward switch terminal C
- Recline forward switch terminal H
- Recline rearward switch terminal G
- If greater than the specified range, replace the adjuster switch switch.