Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of AT Control & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the automatic transmission control (2).

CAUTION: Refer to Fastener Caution .

NOTE: Move the automatic transmission control as needed to install all the automatic transmission control bolts.

Install the automatic transmission control bolts (1) and tighten to 10 N.m (89 lb in).

Fig 2: View Of AT Shift Lock Control Actuator

Courtesy of GENERAL MOTORS CORP.

Connect the automatic transmission shift lock control actuator (1) to the automatic transmission control.

Fig 3: Identifying Park Lock Cable At Ignition Lock Cylinder

Courtesy of GENERAL MOTORS CORP.

Connect the automatic transmission park lock cable (1).
1. Place the ignition lock cylinder into the OFF position.
2. Place the automatic transmission control into the PARK position.
3. Press the locking tab on the end of the automatic transmission park lock cable into the slot in the ignition lock cylinder case.
Install the shift lever. Refer to Shift Lever Replacement .
Install the steering column. Refer to Steering Column Replacement (Without HP2) or Steering Column Replacement (HP2) or Steering Column Replacement (Without HP2 With Electric Tilt Column) .