Component Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Liftglass Latch Assembly
- Ignition OFF, disconnect the harness connector at the rear liftglass latch assembly.
- Install a 20A fused jumper wire between the control terminal 1 and 12 volts. Install a jumper wire between the ground terminal 2 and ground. Verify the liftglass actuator activates.
- If the actuator does not perform as specified, replace the liftglass latch assembly.
Liftglass Release Switch
- Ignition OFF, disconnect the harness connector at the liftglass release switch.
- Test for infinite resistance between the signal terminal A and the ground terminal B with the switch in the open position.
- If not the specified value, replace the liftglass release switch.
- Test for less than 2 Ω between the signal terminal A and the ground terminal B with the switch in the closed position.
- If greater than the specified range, replace the liftglass release switch.