LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 255 (Fixed And MOVEABLE Windows System) >> Repair Instructions >> Windshield Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If the HYBRID decal on the windshield is damaged or if the windshield is being replaced, refer to Decal or Stripe Replacement (Tahoe Hybrid 2 Mode Lower Door) or Decal or Stripe Replacement (Tahoe Hybrid 2 Mode Rear Glass) or Decal or Stripe Replacement (Tahoe Hybrid 2 Mode Windshield) or Decal or Stripe Replacement (Escalade HYBRID 2 Mode Door Decal)
  1. Install a stationary window into the opening. Refer to Adhesive Installation of Stationary Windows (Quarter Window)  or Adhesive Installation of Stationary Windows (Windshield) .
  2. Install the window side reveal moldings to the vehicle.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the screws to the left and the right sides of the window side reveal moldings and tighten to 2 N.m (18 lb in).
  4. Install the front door sealing weatherstrips to the retainer.
  5. Install the cowl air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  6. Install the window wiper arms. Refer to Windshield Wiper Arm Replacement (Chevrolet Hybrid Two-mode) or Windshield Wiper Arm Replacement (Conventional) .
  7. Install the antenna mast, if equipped. Refer to Radio Antenna Replacement .
  8. Install the outside moisture sensor lens. Refer to Windshield Outside Moisture Sensor Lens Replacement .
  9. Install the inside rearview mirror. Refer to Inside Rearview Mirror Replacement .
  10. Close the hood.
  11. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
scientia non olet · About LEMON Manuals