Power Steering Gear Inlet Pipe/Hose Replacement (Gas Without Hydroboost): Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Power Steering Gear Inlet Pipe/Hose & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the engine shield. Refer to Engine Shield Replacement .
1	Power Steering Gear Inlet Hose Fitting CAUTION: Refer to Fastener Caution . Procedure Remove as much power steering fluid from the power steering fluid reservoir as possible. Place drain pans under the vehicle as needed. Tighten: 32 N.m (24 lb ft)
2	Power Steering Gear Inlet Hose Retaining Plate Bolt Tighten: 12 N.m (106 lb in)
3	Power Steering Gear Inlet Hose CAUTION: Refer to Power Steering Hose Disconnected Caution . Procedure Use the remover/installer J 44586 to replace the steering gear seals if necessary. See Special Tools . Fill and bleed the power steering system. Refer to Power Steering System Bleeding . Tip: Note the routing of the power steering gear inlet hose to ensure proper installation. Keep all open connections in the power steering system clean and free of debris.