LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> SRX 4.6 A, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Memory Modules >> Configurable Customer Control System >> Diagnostic Information and Procedures >> Steering Wheel Controls Inoperative (without N31) >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the left and right steering wheel control switches.
  2. Ignition ON, test for B+ between the voltage reference circuit terminal 1 and ground.
    • If less than the specified value, test the voltage reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  3. Test for B+ between the voltage reference circuit terminal 1 and the signal circuit terminals listed below:
    • Steering wheel control switch signal circuit terminal 6 - left switch
    • Steering wheel control switch signal circuit terminal 2 - right switch
    • If less than the specified value, test the signal circuits for a short to voltage or an open/high resistance. If the circuits test normal, replace the BCM.
  4. Ignition OFF, disconnect the X1 harness connector at the BCM.
  5. Test for infinite resistance between ground and the signal circuit terminals listed below:
    • Steering wheel control switch signal circuit terminal 6 - left switch
    • Steering wheel control switch signal circuit terminal 2 - right switch
    • If less than the specified value, test the signal circuits for a short to ground.
  6. Ignition ON, test for less than 1 volt between ground and the voltage reference circuit terminal 5 at the left steering wheel control switch.
    • If greater than the specified range, test the voltage reference circuit for a short to voltage
  7. Ignition ON, test for infinite resistance between ground and the voltage reference circuit terminal 5 at the left steering wheel control switch.
    • If not the specified value, test the voltage reference circuit for a short to ground.
  8. Test for less than 1 ohm between the voltage reference circuit terminal 5 at the left steering wheel control switch and the voltage reference circuit terminal 5 at the right steering wheel control switch.
    • If greater than the specified range, test the voltage reference circuit for a an open/high resistance.
  9. If all circuits test normal, test or replace the left or right steering wheel control switch.
scientia non olet · About LEMON Manuals