Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the X2 harness connector at the radio.
- Ignition ON, test for a varying AC voltage between the following signal circuit terminals listed below and ground when the OnStar® Call Center button is pressed.
- Audio Signal Circuit- terminal 7
- Audio Common Circuit- terminal 15
- If AC voltage was not present, test the circuit for a short to voltage, short to ground, or an open/high resistance. If the circuit tests normal, replace the CIM.
- If all circuits test normal, replace the radio.