Remote Control Door Lock Receiver

If the remote control door lock receiver (RCDLR) is replaced, the following procedures must be performed in the order listed below:

1. Perform the Keyless Entry Transmitter Programming procedure. Refer to Transmitter Programming (North America, except Canada) or Transmitter Programming (Canada, Europe, Asia, Middle East) , using Method 2 to perform the programming.
2. Perform the procedure to set up a new RCLDR:
   1. Connect the Tech 2 to the vehicle.
   2. Select RCDLR under Module Setup in the Vehicle Control System menu.
   3. Select Setup New RCDLR.
   4. Follow the on-screen instructions.
3. Perform the 10-Minute Immobilizer Relearn procedure. Refer to Immobilizer System Component Programming .

   When performing the relearn procedure, select Theft Deterrent Learn for ECM on the SPS terminal.

4. Perform the Tire Pressure Sensor Learn procedure. Refer to Tire Pressure Sensor Learn .