Radio Replacement (Left Hand Drive)

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Radio (LHD)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Left Hand Drive) or Instrument Panel Accessory Trim Plate Replacement (Right Hand Drive) . Remove the instrument panel air outlet. Refer to Instrument Panel Center Air Outlet Replacement (Left Hand Drive) or Instrument Panel Center Air Outlet Replacement (Right Hand Drive) . Remove the HVAC control module. Refer to HVAC Control Module Replacement .
1	Radio Screw (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 2.5 N.m (22 lb in)
2	Radio Assembly Procedure Disconnect the electrical connector. Disconnect the antenna cable. Reprogram the radio after replacement. Refer to Control Module References . Tip: When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.

Callout

Component Name

Preliminary Procedures

Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Left Hand Drive) or Instrument Panel Accessory Trim Plate Replacement (Right Hand Drive) .
Remove the instrument panel air outlet. Refer to Instrument Panel Center Air Outlet Replacement (Left Hand Drive) or Instrument Panel Center Air Outlet Replacement (Right Hand Drive) .
Remove the HVAC control module. Refer to HVAC Control Module Replacement .

Radio Screw (Qty: 4)

NOTE: Refer to Fastener Notice .

Tighten: 2.5 N.m (22 lb in)

Radio Assembly

Procedure

Disconnect the electrical connector.
Disconnect the antenna cable.
Reprogram the radio after replacement. Refer to Control Module References .

Tip: When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.