LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> STS Base, 4.6 A, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Brake Pressure Modulator Valve Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: BPMV
    GM1906553Courtesy of GENERAL MOTORS CORP.
  1. Install the BPMV (1).
    2. Fig 2: BPMV Bolt
    GM1906552Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the BPMV bolt (1) and tighten to 11 N.m (97 lb in).
    3. Fig 3: RF Brake Pipe Fitting
    GM1906551Courtesy of GENERAL MOTORS CORP.
  3. Connect the right front brake pipe fitting (1) and tighten to 20 N.m (15 lb ft).
    4. Fig 4: LR Brake Pipe Fitting
    GM1906549Courtesy of GENERAL MOTORS CORP.
  4. Connect the left rear brake pipe fitting (1) and tighten to 20 N.m (15 lb ft).
    5. Fig 5: RR Brake Pipe Fitting
    GM1906547Courtesy of GENERAL MOTORS CORP.
  5. Connect the right rear brake pipe fitting (1) and tighten to 20 N.m (15 lb ft).
    6. Fig 6: LF Brake Pipe Fitting
    GM1906546Courtesy of GENERAL MOTORS CORP.
  6. Connect the left front brake pipe fitting (1) and tighten to 20 N.m (15 lb ft).
  7. Connect the EBCM electrical connector
  8. Position the washer solver container and install the fasteners. Refer to Windshield Washer Solvent Container Replacement (Without CE4) or Windshield Washer Solvent Container Replacement (With CE4) .
  9. Install the front air deflector shield. Refer to Front Air Deflector Replacement .
  10. Lower the vehicle.
    11. Fig 7: Primary BPMV Inlet Brake Pipe Fitting
    GM1906545Courtesy of GENERAL MOTORS CORP.
  11. Connect the primary BPMV inlet brake pipe fitting (1) and tighten to 32 N.m (24 lb ft).
    12. Fig 8: Pressure Modulator Valve Inlet Brake Pipe Fitting
    GM1906544Courtesy of GENERAL MOTORS CORP.
  12. Connect the secondary BPMV inlet brake pipe fitting (1) and tighten to 32 N.m (24 lb ft).
  13. Install the RH front compartment sight shield. Refer to Front Compartment Sight Shields Replacement .
  14. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure) or Hydraulic Brake System Bleeding (Manual) .
  15. Perform the Antilock Brake System Automated Bleed .
  16. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals