Circuit/System Verification
- Verify that DTCs P0112, P0113, P0116, P0117, P0118, P0197, or P0198 are not set.
- If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Ignition ON, observe the scan tool Engine Oil Temperature Calculated and the Engine Oil Temperature Sensor parameters. The readings should be within 30°C (54°F) of each other.
- Ignition ON, observe the scan tool IAT Sensor, ECT Sensor, and Engine Oil Temperature Sensor parameters. The readings should be within 15°C (27°F) of each other and also the ambient temperature.
- Operate the vehicle within the Conditions for Running the DTC to verify that the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
IMPORTANT:
Perform the following verification procedure only if the ignition has been OFF for 10 hours or more.