Circuit/System Testing
WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the noise compensation microphone harness connector.
- Ignition ON, test for less than 9.5 volts at the supply voltage terminal B.
- If greater than the specified value, repair short to voltage.
- Ignition OFF, test for greater than 1 ohm between the supply voltage terminal B and ground.
- If less than specified value, repair short to ground.
- Disconnect C3 amplifier harness connector.
- Test for less than 1 ohm of resistance between the noise compensation microphone harness connector terminal B and amplifier harness connector terminal 14.
- If greater than the specified value, repair open/high resistance.
- Test for less than 1 ohm of resistance between the noise compensation microphone harness connector terminal A and amplifier harness connector terminal 6.
- If greater than the specified value, repair open/high resistance.
- If all circuits test normal, test or replace the noise compensation microphone.