Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Lower Control Arm-To-Lower Control Arm Bracket Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

Install the lower control arm by installing the lower control arm on the ball stud and moving the lower control arm up to the cradle.
Install the lower control arm to cradle bolts.
NOTE: Refer to Fastener Notice .
Install the lower control arm to cradle nuts.
Tighten: Tighten the nuts to 135 N.m (96 lb ft).

Fig 2: View Of Power Steering Gear Mounting Bolts
Courtesy of GENERAL MOTORS CORP.
Tighten the power steering gear retaining bolts.
Tighten: Tighten the bolts to 120 N.m (89 lb ft).

Fig 3: View Of Lower Control Arm Ball Stud-To-Steering Knuckle Retaining Nut
Courtesy of GENERAL MOTORS CORP.
Install the lower control arm to steering knuckle nut.
Tighten:
1. Tighten the nut to 20 N.m (15 lb ft).
2. Tighten the nut to an additional 210 degrees.
Install the ABS wire harness to the lower control arm.

Fig 4: View Of Stabilizer Shaft Link Lower Retaining Nut
Courtesy of GENERAL MOTORS CORP.
Install the stabilizer shaft link to the lower control arm.
Install the stabilizer shaft link lower retaining nut.
Tighten: Tighten the nut to 110 N.m (81 lb ft).
Install the shock module yoke to the lower control arm. Refer to Shock Module Yoke Replacement .
Install the air deflector. Refer to Front Air Deflector Replacement .
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.
Align the front end. Refer to Measuring Wheel Alignment .