Remote Control Door Lock Receiver

If the remote control door lock receiver (RCDLR) is replaced, the following procedures must be performed in the order listed below:

1. Perform the Keyless Entry Transmitter Programming procedure-Refer to Transmitter Programming (N. America and Japan, except Canada) or Transmitter Programming (Canada and Europe) or Transmitter Programming (New RCDLRs ONLY) Select Transmitter Programming for New RCDLRs ONLY.
2. Perform the procedure to set up a new remote control door lock receiver:
   1. Connect the Tech 2 to the vehicle
   2. Select RCDLR under Module Setup in the Vehicle Control System menu.
   3. Select Setup New RCDLR.
   4. Follow the on-screen instructions.
3. Perform the Theft Deterrent 10-Minute or 30-Minute Relearn Procedure for the Engine Control Module (ECM) -Refer to Immobilizer System Component Programming , selecting the Programming Theft Deterrent System Components that matches your vehicles country of origin.

   During the ECM programming, select Theft Deterrent Learn for ECM on the SPS terminal.

4. Perform the tire pressure sensor learn procedure, (if equipped)-Refer to Tire Pressure Sensor Learn .