LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> XLR Base >> Repair and Diagnosis (Single Page) >> General Information >> OEM General Information >> Vehicle Diagnostic Information >> Specifications >> Steering Column Lock Control Module Scan Tool Information
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Column Lock Control Module Scan Tool Information

Steering Column Lock Module Scan Tool Data Parameters

Parameter System State Expected Value Description
Operating Conditions:  Engine ON
Battery Voltage Signal - Varies This displays Volts. This is the current battery voltage signal.
Column Feedback Signal - Varies This displays Volts. This is the current column feedback signal.
Column Lock Enable Signal - Disabled The scan tool displays Enabled or Disabled. This is the state of the column lock enable signal.
Column Lock Module Status - Disabled The scan tool displays Enabled or Disabled. This is the state of the column lock module.
Column Lock Motor Command - Idle The scan tool displays Idle, Unlock, Lock or Invalid. This is the state of the column lock motor command.
Column Lock Motor Status - Idle The scan tool displays Idle, Unlock, Lock or Invalid. This is the state of the column lock motor.
Column Lock Status - Unlocked The scan tool displays Locked, Unlocked, Unlk Volt Delay, Column Unlocking, Unlock Failure, Column Locking, Locking Failure, Lock Fail Unlk, Lock Fail Stdby, Unlk Batt Reconn, Batt Reconnected, Disabled Unlk., Fail Enable Lock, Fail Enab. Latch, Fail Enab. Unlk., Fail Enab. Stdby, Config. Conflict or Override Disable. This is the state of the column lock.
Ignition Voltage Signal - Varies This displays Volts. This is the current state of the ignition voltage signal.
Park Switch - On The scan tool displays On or Off. This is the state of the park switch.
Password Status - Valid The scan tool displays Valid, Invalid or Not Programmed.
Steering Column Lock Module Scan Tool Output Controls

Scan Tool Output Control Description
Column Lock The steering column lock module can be commanded by using the scan tool to energize the column lock enable circuit.
Column Unlock The steering column lock module can be commanded by using the scan tool to energize the column unlock enable circuit.