Removal Procedure
CAUTION:
To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
- Turn the ignition switch to the OFF position.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Clean the area surrounding the electronic brake control module (EBCM) and the brake pressure modulator valve (BPMV) of and dirt and debris.
- Disconnect the EBCM electrical connector.
- Remove the EBCM bolts (1).
- Remove the EBCM (1) by carefully pulling straight away from the BPMV.
Do not force the components apart.
- Clean the mating surfaces of the EBCM and the BPMV with denatured alcohol and allow to dry.
NOTE:
Do not attempt to pry or lever the EBCM from the BPMV.