LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Anti-Lock Brake System, Traction Control System & Stability Control System) >> Diagnostic Information and Procedures >> DTC C0110 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the EBCM.
  2. Test for less than 5 ohms of resistance between the ground circuits terminals E and F and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the B+ circuits terminals A and B and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the B+ circuit fuse is open, test or replace the BPMV.
  4. Ignition OFF, remove the EBCM from the BPMV.
  5. Inspect the EBCM to BPMV connector to insure there is no damage, corrosion, or presence of brake fluid.
    • If connector corrosion or damage is evident, replace the BPMV and/or EBCM as necessary.
    • If brake fluid is present, replace both the BPMV and EBCM.
  6. If all circuits test normal, replace the BPMV.
scientia non olet · About LEMON Manuals