LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Suspension Control System - Automatic Level Control) >> Repair Instructions >> Automatic Level Control Sensor and Bracket Replacement - Front >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the sensor to the vehicle.
    Fig 1: View Of Front Ride Sensor
    GM1371680Courtesy of GENERAL MOTORS CORP.
  2. Install the ride sensor retaining nut.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

    NOTE: Refer to Fastener Notice .
  3. Connect the ride sensor link to the upper control arm ball stud.
    Fig 2: View Of Front Ride Sensor Link
    GM1371682Courtesy of GENERAL MOTORS CORP.
  4. Connect the ride sensor harness connector.
  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals