Remote Control Door Lock Receiver Replacement

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Remote Control Door Lock Receiver Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the side door opening frame garnish molding. Refer to Side Door Opening Frame Garnish Molding Replacement . Remove the body side rear upper garnish molding. Refer to Body Side Rear Upper Garnish Molding Replacement (w/ TB5) or Body Side Rear Upper Garnish Molding Replacement (w/o TB5) .
1	Storage Bin Liner
2	Storage Bin Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
3	Storage Bin
4	Remote Control Door Lock Receiver Procedure The module slides and snaps into the storage bin. Disconnect the electrical connector. If a replacement module is installed, program the module. Refer to Control Module References .