LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2010 >> CTS V, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Object Detection System >> Diagnostic Information and Procedures >> DTC B1E3A >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at each of the object alarm sensors.
  2. Ignition ON, verify DTC B1E3A is not set as current.
    • If DTC is set, test the 8 V reference circuit terminal 1 for a short to voltage, short to ground, or an open/high resistance. If circuit tests normal, replace the rear object sensor control module.
  3. Install each sensor harness connector one at a time, checking DTCs after each sensor is connected. Verify DTC B1E3A is not set as current.
    • If DTC is set, replace the object alarm sensor that was connected immediately before the DTC set.
scientia non olet · About LEMON Manuals