LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2010 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Object Detection System >> Diagnostic Information and Procedures >> Parking Assist System Malfunction >> Circuit/System Verification
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Verification

  1. Ignition ON, verify the parking assist system is enabled through the DIC.
    • If the parking assist system is manually disabled, enable the system. Refer to the vehicle owners manual for instructions on enabling the system.
  2. Observe the scan tool Park Assist Switch parameter while pressing and releasing the park assist disable switch. The parameter should change between Active and Inactive.
    • If the parameter does not cycle between the specified values, refer to Park Assist Disable Switch Circuit Malfunction.
  3. Observe the scan tool Park Assist Switch LED parameter while pressing and releasing the park assist disable switch. The parameter should change between On and Off.
    • If the parameter does not cycle between the specified values, refer to Park Assist Disable LED Circuit Malfunction.
  4. Transmission in REVERSE, verify one audible beep sounds and the scan tool Park Assist System Status parameter is Enable.
    NOTE: After completing the next step the vehicle might need to be driven in the forward direction at speed greater than 40 km/h (25 mph).
    • If not the specified values, refer to Diagnostic Aids and the scan tool Park Assist Disable History parameters to determine the cause of the inhibit.
scientia non olet · About LEMON Manuals