Component Testing

Static Test

1. Ignition OFF, remove the Camshaft Position Actuator Magnet.
2. Test for 5.0-9.0 Ω between the solenoid control terminal 2 and the low reference terminal 1 at the Camshaft Position Actuator Magnet.
   • If not within the specified range, replace the Camshaft Position Actuator Magnet.
3. Test for infinite resistance between each terminal of the magnet and the magnet housing.
   • If not the specified value, replace the Camshaft Position Actuator Magnet.

Dynamic Test

1. Remove the Camshaft Position Actuator Magnet.
NOTE:
• The Camshaft Position Actuator Magnet pintle should be facing downward for this test.
• Do not allow electrical current to flow through the Camshaft Position Actuator Magnet for greater than 1-2 s.
2. Install a 20 A fused jumper wire between the control circuit terminal 2 and B+. Momentarily install a jumper wire between the low reference terminal 1 and ground. The pintle should extent.
   • If the function does not perform as specified, replace the Camshaft Position Actuator Magnet.