Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- To successfully diagnose and repair the OnStar® system it is necessary to comprehend its operation. Technicians should read and understand the OnStar Description and Operation before attempting to repair an OnStar® system. This symptom below will enable the user to verify the customer complaint and narrow it to its source. If there is a concern with voice recognition or OnStar® steering wheel control function, technicians should proceed directly to the applicable diagnostic in Symptoms - Cellular Communication .
- It is important to have the vehicle in an open outside area where a cellular call can be successfully placed and GPS data can be received from satellites.
- It is necessary to inform the OnStar® Call Center advisor that this call is for vehicle diagnostic purposes.
- Ignition ON, observe that the OnStar® status LED turns green.
- If the LED does not turn green, refer to OnStar Button LED Inoperative .
- Radio ON, set the volume to a comfortable level.
- Press the OnStar® Call Center button and observe that the OnStar LED blinks.
- If the OnStar® LED does not blink, refer to OnStar One or More Buttons Inoperative .
- Listen that the radio muted and the Connecting to OnStar message played through the audio system.
- If the radio did not mute or the Connecting to OnStar message did not play, refer to No (or Noisy) OnStar Audio .
- Wait approximately 10 seconds, then end the call by pressing the white dot button and observe the OnStar LED stops blinking.
- If the OnStar® LED continues blinking, refer to OnStar One or More Buttons Inoperative .
- Press the OnStar® Call Center button and ensure that a connection was made with OnStar®.
- If the Unable to Contact OnStar® was heard, refer to Unable to Contact OnStar Call Center .
- If the OnStar® Request Ended was heard, go to Diagnostic Aids.
- Ensure that OnStar® Call Center advisor can hear your voice clearly.
- If the advisor cannot hear you clearly, refer to OnStar Microphone Inoperative - Caller Cannot Be Heard .
- Ensure that OnStar® Call Center advisor received a data transfer from the vehicle.
- Ensure with the OnStar® Call Center advisor the vehicle has been configured.
- If the vehicle has not been configured, refer to Control Module References
- Verify with the OnStar® Call Center advisor that the vehicle identification number (VIN) which they have on record matches the actual VIN.
- Verify that your position with the OnStar® Call Center advisor is within a reasonable distance from the actual location of the vehicle.
- If not within a reasonable distance, refer to OnStar Global Positioning System (GPS) Data Not Current or Inaccurate .
- Verify with the OnStar® Call Center advisor that the GPS position is marked as Current.
- If not current, refer to OnStar Global Positioning System (GPS) Data Not Current or Inaccurate .
- Ensure that the customer concern is the inability of the OnStar® Call Center to perform remote functions.
- If the OnStar® Call Center is able to perform remote functions, go to Diagnostic Aids.
- Refer to OnStar Call Center Remote Function Requests Inoperative .