Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the appropriate window motor.
- Connect a test lamp between control circuit terminal A and control circuit terminal B.
- Ignition ON, command the window UP and DOWN by using the door switch. The test lamp should turn ON when commanding the UP and DOWN states.
- If the test lamp is always OFF during either of the commands, test either control circuit for a short to ground or open/high resistance. If the circuits test normal, replace the door switch.
- If the test lamp is always ON, test either control circuit for a short to voltage. If the circuits test normal, replace the door switch
- If all circuits test normal, test or replace the window motor.