Component Testing
IMPORTANT:
When performing the following tests, make sure that the window motor is not all ready in the position the test is attempting to produce.
- Ignition OFF, disconnect the harness connector at the appropriate window motor.
- Install a 25A fused jumper wire between the control terminal A and 12 volts. Momentarily install a jumper wire between the control terminal B and ground. The window motor should perform the UP or DOWN function.
- If the function does not perform as specified, replace the window motor.
- Reverse the jumper wires; the window motor should perform the DOWN or UP function.
- If the function does not perform as specified, replace the window motor