LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2010 >> Escalade EXT >> Repair and Diagnosis >> Body & Frame >> Fixed And MOVEABLE Windows System >> Repair Instructions >> Windshield Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    NOTE: If the HYBRID decal on the windshield is damaged or if the windshield is being replaced, refer to Decal or Stripe Replacement (Tahoe Hybrid 2 Mode Lower Door) or Decal or Stripe Replacement (Tahoe Hybrid 2 Mode Rear Glass) or Decal or Stripe Replacement (Tahoe Hybrid 2 Mode Windshield) or Decal or Stripe Replacement (Escalade HYBRID 2 Mode Door Decal)
  1. Install a stationary window into the opening. Refer to Adhesive Installation of Stationary Windows (Quarter Window)  or Adhesive Installation of Stationary Windows (Windshield) .
  2. Install the window side reveal moldings to the vehicle.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the screws to the left and the right sides of the window side reveal moldings and tighten to 2 N.m (18 lb in).
  4. Install the front door sealing weatherstrips to the retainer.
  5. Install the cowl air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  6. Install the window wiper arms. Refer to Windshield Wiper Arm Replacement (Chevrolet Hybrid Two-mode) or Windshield Wiper Arm Replacement (Conventional) .
  7. Install the antenna mast, if equipped. Refer to Radio Antenna Replacement .
  8. Install the outside moisture sensor lens. Refer to Windshield Outside Moisture Sensor Lens Replacement .
  9. Install the inside rearview mirror. Refer to Inside Rearview Mirror Replacement .
  10. Close the hood.
  11. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
scientia non olet · About LEMON Manuals