DTC Set By The Audio Amplifier
WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the inoperative speaker.
- Ignition ON, radio ON, test for 5.0-7.5 volts between the inoperative speaker output positive (+) circuit and ground.
- If less than the specified range, test the output circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the audio amplifier.
- If greater than the specified range, test the output circuit for a short to voltage. If the circuit tests normal, replace the audio amplifier.
- Ignition ON, radio ON, test for 5.0-7.5 volts between the inoperative speaker output negative (-) circuit and ground.
- If less than the specified range, test the output circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the audio amplifier.
- If greater than the specified range, test the output circuit for a short to voltage. If the circuit tests normal, replace the audio amplifier.
- If all circuits test normal, test or replace the inoperative speaker.