LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2011 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 1114 (Anti-Lock Brake System, Traction Control System & Stability Control System) >> Diagnostic Information and Procedures >> DTC C0292 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the yaw rate and lateral acceleration sensor connector.
  2. Ignition OFF, test for less than 1 ohm of resistance between the low reference circuit terminal 6 and ground.
    • If greater than 1 ohm, test the low reference circuit terminal 6 and the EBCM ground circuit terminal 25 for an open/high resistance. If the circuits test normal, replace the EBCM.
  3. Test the lateral accelerometer 12-volt reference circuit terminal 1, for an open/high resistance or a short to voltage or ground.
    • If all circuits test normal, replace the yaw rate sensor/lateral acceleration sensor, and clear the yaw rate sensor offset value in the EBCM.
    • If the DTC sets again after replacing the yaw rate sensor/lateral acceleration sensor, replace the EBCM.
scientia non olet · About LEMON Manuals