LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2011 >> Escalade EXT >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC P0622 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Verify that a test lamp illuminates between the B+ circuit ring terminal 1 X2 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  2. Ignition OFF, disconnect the X1 harness connector at the generator.
  3. Ignition ON, verify the scan tool ECM GEN-F Terminal Signal parameter is less than 5 percent.
    • If greater than the specified range, test the field duty cycle circuit terminal 2 X1 for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Install a 3A fused jumper wire between the field duty cycle circuit terminal 2 X1 and B+. Verify the scan tool ECM GEN-F Terminal Signal parameter is greater than 95 percent.
    • If less than the specified range, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test or replace the generator.
scientia non olet · About LEMON Manuals