Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the LF door handle antenna.
- Ignition ON, verify a test lamp does not illuminate between the signal circuit terminal 1 and ground.
- If the test lamp illuminates, test the signal circuit for a short to voltage. If the circuit tests normal, replace the RCDLR.
- Install a DMM between the signal circuit terminal 1 and the low reference circuit terminal 2. Set the DMM to capture AC voltage using the MIN MAX function.
- Perform the Left Door Handle Antenna special functions test. Verify the DMM captured an AC voltage signal.
- If an AC voltage was not captured, test the signal circuit and the low reference circuit for a short to ground or an open/high resistance. If the circuits test normal, replace the RCDLR.
- If all circuits test normal, test or replace the LF door handle assembly.