LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade Base, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Cellular System, Entertainment System, And Navigation System >> Diagnostic Information and Procedures >> Video Entertainment System Remote Control Malfunction >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

NOTE:

Test or replace the remote batteries before performing the circuit/system test.

  1. Ignition OFF, disconnect the harness connector at the infrared transmitter.
  2. Ignition OFF, test for less than 5.0 ohms between the ground circuit terminal 12 and ground.
    • If greater than specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, DVD playing, test for B+ between the infra red module control circuit terminal 4 and ground.
    • If less than specified value, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the rear seat audio module.
  4. Ignition ON, DVD playing, test for 0.75-2 volts between the remote infra red signal (+) circuit and ground.
    • If less than specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
    • If greater than specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
  5. Ignition ON, DVD playing, test for less than 1 volt between the remote infra red signal (-) circuit and ground.
    • If greater than specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
  6. Reconnect the harness connector at the infrared transmitter, and disconnect the X3 harness connector at the radio.
  7. Ignition ON, DVD playing, test for 4-6 mV AC between the remote infra red signal (+) circuit and ground.
    • If less than specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the infrared transmitter.
    • If greater than specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the infrared transmitter.
  8. Ignition ON, DVD playing, test for 4-6 mV AC between the remote infra red signal (-) circuit and ground.
    • If less than specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the infrared transmitter.
    • If greater than specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the infrared transmitter.
  9. Ignition ON, DVD playing, press any button on the remote control aimed at the infrared transmitter and test for 300-330 MHz between the remote infra red signal (+) circuit and ground.
    • If not within the specified range, replace the remote control.
  10. If all circuits test normal, replace the radio.
scientia non olet · About LEMON Manuals