LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1128 (Keyless Entry System & Remote Functions) >> Diagnostic Information and Procedures >> DTC B3601 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the key capture solenoid.
  2. Test for less than 5 ohms between the ground circuit terminal 1 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Connect a test lamp between the control circuit terminal 2 and the ground circuit terminal 1.
  4. Command the Key Capture Solenoid ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for short to voltage. If the circuit tests normal, replace the RCDLR.
    • If the test lamp is always OFF, test the control circuit for short to ground or an open/high resistance. If the circuit tests normal, replace the RCDLR.
  5. If all circuits tests normal, test or replace the key capture solenoid.
scientia non olet · About LEMON Manuals