LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System And Washer System >> Diagnostic Information and Procedures >> DTC B3873 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the X4 harness connector at the BCM.
  2. Ignition ON, verify the windshield washer pump is not on.
    • If the windshield washer pump is on, test the windshield washer pump relay control circuit terminal 15 for a short to ground. If the circuit tests normal replace the underhood fuse block.
  3. Install a 10A fused jumper wire between the relay control circuit terminal 15 and ground. Verify the windshield washer pump is on.
    • If the windshield washer pump is not on, test the relay control circuit for a short to voltage or an open/high resistance. If the circuit tests normal replace the underhood fuse block.
  4. If all circuits test normal, replace the BCM.
scientia non olet · About LEMON Manuals