Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the rear window wiper motor.
- Ignition ON, connect a test lamp between the signal circuit terminal B and ground.
- Command the liftglass latch to release by pressing the liftgate window release switch. The test lamp should briefly illuminate when the liftgate window release switch is pressed.
- If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
- If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
- If all circuits test normal, replace the rear window wiper motor.