Liftgate Close Actuator Motor Control Module Replacement (Except Avalanche and Escalade EXT)

Fig 1: View Of Liftgate Actuator Drive Unit Bolts

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the bodyside trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/E61) , Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/E61) , Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/o E61) , Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/o E61) . Disconnect the power liftgate actuator rod. Refer to Liftgate Actuator Rod Replacement (Except Avalanche and EXT Escalade) .
1	Liftgate Close Actuator Motor Control Module Procedure Disconnect the electrical connector. Cut the tie strap, if equipped.
2	Liftgate Close Actuator Motor Control Module Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
3	Liftgate Close Actuator Motor Control Module Procedure If a replacement control module is installed, program the module. Refer to Control Module References .