Circuit/System Testing
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the generator.
- Ignition ON, engine OFF, observe the scan tool ECM GEN-F Terminal Signal parameter. It should display less than 10 percent.
- If the GEN-F Terminal Signal parameter was not affected by the disconnected generator harness, test the GEN-F Terminal Signal circuit terminal 2 for a short to voltage. If the circuit tests normal, replace the ECM.
- If the circuit tested normal and the ECM parameter changed from above 65 percent to less than 10 percent, replace the generator.