Removal Procedure
WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the high voltage system. Refer to High Voltage Disabling .
- Remove the auxiliary bussed electrical center (BEC) cover (1).
- Remove the positive battery cable nut (1) from the mega fuse stud.
- Remove the positive battery cable lead (5) from the mega fuse stud.
- Remove the engine shield. Refer to Engine Shield Replacement .
- Remove the positive battery cable clips (2, 3, and 4) from the frame crossmember.
- Lower the vehicle enough to remove the right wheelhouse panel. Refer to Wheelhouse Panel Replacement - Right Side (HP2) .
- Working through the wheel opening, remove the positive battery cable clip (2) from the brake pipe.
- Working through the wheel opening, remove the positive battery cable clip (3) from the air cleaner adapter bracket
- Lower the vehicle.
- Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
- Remove the positive battery cable clip (4) from the air cleaner support bracket.
- Remove the positive battery cable clip (5) from the fender inner panel.
- Disconnect the positive battery cable electrical connector (1) from the drive motor generator control module.
- Remove the positive battery cable (1) from the vehicle.