LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1265 (Steering Linkage) >> Repair Instructions >> Relay Rod Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
  2. Remove the steering linkage shock absorber from the relay rod, if equipped. Refer to Steering Linkage Shock Absorber Replacement .
    3. Fig 1: View Of Idler Arm & Relay Rod
    GM1862675Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Discard the idler arm nut (6) and the pitman arm nut (4).
  3. Remove the steering linkage inner tie rods (3). Refer to Steering Linkage Inner Tie Rod Replacement .
  4. Remove the idler arm nut (6) and separate the idler arm (1) from the relay rod (5) using puller J 24319-B  .
  5. Remove the pitman arm nut (4) and separate the pitman arm (2) from the relay rod (5) using puller J 24319-B  .
  6. Remove the relay rod (5) from the vehicle.
  7. Inspect the threads and seals on all steering related components. Repair or replace components as needed.
scientia non olet · About LEMON Manuals