LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1310 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> DTC B3875 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X5 harness connector at the BCM.
  2. Install a 10A fused jumper wire between B+ and the WIPER CONTROL relay control circuit terminal 20.
  3. Ignition ON, verify that the high speed wipers are not on.
    • If the high speed wipers are on, test the WIPER SPEED relay control circuit terminal 21 for a short to ground. If the circuit tests normal, replace the underhood fuse block.
  4. Install a 10A fused jumper wire between the WIPER SPEED relay control circuit terminal 21 and ground. Verify the high speed wipers are on.
    • If the low speed wipers are not on, test the relay control circuit for a short to voltage or an open/high resistance. If the circuit tests normal replace the underhood fuse block.
  5. If all circuits test normal, replace the BCM.
scientia non olet · About LEMON Manuals