Windshield Wiper Motor Dynamic Test
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the windshield wiper motor.
- Install a 25-amp fused jumper wire between B+ and the control terminal 1. Install a jumper wire between the terminal 5 and ground.
- The wiper motor should be in low speed mode.
- If the wiper motor is not in the low speed mode replace the motor.
- Install a 25-amp fused jumper wire between B+ and the control terminal 4. Install a jumper wire between the terminal 5 and ground.
- The wiper motor should be in the high speed mode.
- If the wiper motor is not in the high speed mode replace the motor.