Circuit/System Testing
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the appropriate front window motor.
- Connect a test lamp between the control circuit terminal A and control circuit terminal B.
- Ignition ON, command the window UP and DOWN by using the front door window switch. The test lamp should illuminate when commanding the UP and DOWN states.
- If the test lamp is always OFF during either of the commands, test either control circuit for a short to ground or an open/high resistance. If the circuits test normal, replace the door module.
- If the test lamp is always ON, test either control circuit for a short to voltage. If the circuits test normal, replace the door module.
- If all circuits test normal, test or replace the front window motor.